DigiMash Upgrade Kit for 35L DigiBoil | Gen 1

Please note: This kit is intended for use with Gen 1 35L DigiBoils (BE501 / BE502). It has a slightly larger wire support ring that may not fit Gen 2 DigiBoils (BE515 / BE516). See related product for the Gen 2 DigiMash Upgrade Kit.

Includes:

• False bottom
• Malt pipe
• Wire support
• Malt pipe handle
• Malt pipe bottom screen

Installation & Use:

• Place the false bottom inside the kettle
• Install the wire support in the channel located at the top of the kettle
• Place the mesh screen inside the malt pipe and attach the handle
• Lower the malt pipe into the kettle so it rests on the wire support
• Fill with strike water and heat to desired strike temperature
• When desired temperature is reached, add grain and stir until well mixed
• When your mash is complete, use the handle to lift out malt pipe and rotate 90° so the malt pipe feet sit on the wire support
• Allow the wort to drain into the kettle and sparge the grain with warm water (165-175°F)
• When you're done collecting your wort, remove the malt pipe and proceed to boil

Please note: only the 500-watt element should be used to increase mash temperatures when the Malt Pipe is in place. Using the higher watt element(s) with the Malt Pipe inserted may cause scorching of the grain.

Kegland Part Number: KL12980